When the icon shown in the figure below appears, the VCM update is complete and it can be used normally. When the upgrade completed, the following prompt interface will appear, and the VCM II will automatically restart,wait until you hear the “beep”. When you see the following image, it means you enter the recovery mode.Īfter clicking on the “Recover” button, the program will switch to the VCMII Update interface.Ĭlick on “Start Update” to start the firmware update, and the following image will appear “Do not unplug the VCM II from the PC or remove power from the VCM II during the update process.”Īfter clicking on “OK”, the following image will appear to start writing the new version of firmware.

Run BoschVCI Software(Ford-VCM-II)VCI Manger(Ford-VCM-II). It appears everything is working as it should now.Ĭonnect the USB cable to the VCM2 device and hold the (ReSet) button shown as below.Ĭonnect the other end of the USB to a computer with IDS V86 installed, and then release the ReSet button until you hear a beep sound. Problem:Finished installing the IDS v86 software but now it won’t recognize the VCM2.įeedback: I was able to update with vci. I also updated IDS to version 95.05 and using a 3 day trial after upgrading from version 91.01. Solution: I reinstalled the firmware in recovery mode using FordVCMIISoftwareSetupv2.1.119.3 from the BOSCH website. If your computer is not already connected wireless to the internet, use Microsoft Windows’ Wireless Manager to connect your IDS computer to your locations wireless Access Point or Router. How to Solve VCM II cannot connect to PCM Here are solutions and suggestion of VCM II and PCM connection failure. Recently, CnAutotool has received some question about Ford VCM2 firmware downgrade, Following is a detailed description and solution of the problem. The VCM II will not connect to a wireless Router or Access point if the D-Link adapter is present.

Vcm 2 will not connect to computer